최신 Cisco Specialist 600-601 무료샘플문제:

1. Which two commands can help you to determine what image is running on your industrial switch? (Choose two.)

A) show interface-switch
B) show license
C) show version
D) show spanning-tree
E) show interfaces gigabitEthernet x/y switchport

2. Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits that represent the subnet mask?

A) 255.255.255.248 and /27
B) 255.255.255.240 and /28
C) 255.255.255.224 and /26
D) 255.255.255.248 and /28
E) 255.255.255.192 and /25
F) 255.255.255.240 and /16

3. Exhibit: Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

A) CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.
B) Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.
C) IEEE1588 and PTP are important for ensuring real-time synchronization.
D) EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
E) The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.
F) EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.

4. Which two reasons make mesh bonding systems most effective? (Choose two.)

A) provide additional strength to floor structures
B) create equipotential grounding systems
C) cover wide areas
D) most cost-effective approach
E) provide low-impedance noise-equalizing paths

5. What is the purpose of a time domain reflectometer?

A) It opens shorts and pinholes in cable shielding.
B) It opens kinks and mismatched cable connectors.
C) It correlates the returned light pulses with a location in the fiber.
D) It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices, bridge taps, split pairs, and other problems.

질문과 대답: